Recent content by diehard3

I bought one and was junk the sensors pushed in and held with a clip, they wobbled in houseing and loosely fit, I put my original ford back in didn't leak when I pulled eng out of donor.

No ports are diff and bolt patterns not even close .

Nice I plan on building a rear pan in place of bumper

I have to do the same I used the same mount brackets off ohv engine and installed them on engine I too going to notch frame but when I look down the center line of engine it's got the tail shaft pointing toward pass side I'm hoping notching the frame will solve this.

Great Much appriciate! Tks!

Will it run ok on my old tank if I switch the fuel rail to a 97 then if so I'll not change the tank

Tks buddy so much!

With 94 pcm

01 going in 94 truck with it pcm

Can I use the 01 tank and fuel pump ,will it work with obd1 with the 01 4.0 fuel rail?

Can I use the 01 sohc tank and pump to run on the 94 ecm and use the fuel lines from the 01 tank ?

Just a newer 4.0 with new cassettes and headers ,clean frame up and so in.

Removing entire front end after all rivets removed!