DannyG's latest activity
-
DDannyG replied to the thread Denise the family hauler.First time sitting on its own weight! Man that was a huge milestone for the build.
-
-
DNice work, awesome build. Everything looks on point.
-
DMannn side of those are looong mig pulls!
-
DDannyG replied to the thread Denise the family hauler.No, King 3.0 ibp I was dead set on running 3.5” but Keith Marigold advised me to stick with 3.0 because there’s way more spring rates...
-
DDannyG replied to the thread Denise the family hauler.Trailing arms wrapped up. Simple 2d arms, all 4130 construction. 1.75”x.125” lower tube with .125” pocket, .090” vertical center...
-
-
DDannyG replied to the thread Denise the family hauler.Couple shots of the added ram assist from Lee Power Steering
-
-
DDannyG replied to the thread Denise the family hauler.Dana 50 swingset steering. Since there is nothing commercially available for the D50 respective to steering, I set out to build my own...
-
-
DDannyG replied to the thread Denise the family hauler.Coolers! I decided to build my own coolers rather than purchasing them. The radiator is 2011 Duramax NAPA replacement. I pulled the end...
-
-
DDannyG replied to the thread Denise the family hauler.Cut & sleeved the axles, massaged the Ujount on the slip yoke of the driver side beam and was able to achieve nearly 20” of functional...
-
-
DDannyG replied to the thread Denise the family hauler.Radius arms built out, time to cycle the front suspension. There’s some massaging of a few sections of the frame to yeild more up...
-
-
DDannyG replied to the thread Denise the family hauler.I did weld as much of the driver side beam as possible with the diff bolted in place. Other than that i didn’t do any type of fixturing.
-
DBeams look awesome!
-
DDannyG replied to the thread Denise the family hauler.Beams!! I pulled the Dana 50 beams from the donor truck and sandblasted them. I purchased a 4.5” over plate kit from Threat Motorsports...
-
-
DDannyG replied to the thread Denise the family hauler.Fuel tank fabrication time! I elected to build a fuel “tank” instead of a traditional cell with a flexible foam filled bladder. After...
-
-
DDannyG replied to the thread Denise the family hauler.Rear floor & firewall section sealed back up using 18ga CR sheet, rear seat mounts in there too. Picked up a donor truck for the Dana 50...
-
