4XForOffroad's latest activity
-
NGUYEN WORKS LOW PRO BUMPER! SHOUT OUT KNOTICAL VENTURES! -
I totally agree those frame plates were welded in by me on the passenger side but after seeing how it came out my buddy has welded the...
-
Been in a bit of a holding pattern waiting for parts to show up. So I pivoted from the back half over to figuring out a bumper + skid...
-
Somebody got new cowboy boots. I really like the new look. It’s turning out to be an amazing mall crawler, if I could just fit in a...
-
Got a Auxbeam switch panel, this way I can wire everything to it and clean up the awful wiring job in the truck. I still haven’t figured...
-
Got a new front bumper off of the marketplace. Had to do some minor trimming but nothing big. Fits pretty well and I just like the stock...
-
-
That bottom part is pretty bad. I recommend cutting off and doing new templates out of cardboard. Draw a line along the center of the...
-
4XForOffroad reacted to Down For Mobbing's post in the thread Equal length beams + Ford 9" housing with
Like.
-
What up? Been lurking for awhile, figured it was time to see what’s it’s all about lol Im from the Burbank cali area. Been on DR and a...
-
4XForOffroad reacted to 85Yota's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
No pics but grind bevel on tubes did 3 passes and then slid in axles, measured gap between axle and hub and cut end of axle the length...
-
Yes I did
-
2wd Front Suspension kit includes: -Camburg Coil buckets and extended shock mounts (1/4" plate) -Radius arms -Autofab bent beams -OEM...
-
4XForOffroad replied to the thread 88 Runner.Did you move the delrin inserts over to the f67’s?
-
F67s feel and look way better than the h70s Co dawg is stoked Gotta get started on wheel wells then adding the rear bedsides